Top 4 stainless steel slip on flanges manufacturer in india

We at Akai Metal India Manufacture stainless steel flanges according to ASME, EN, ISO, and DIN standards. Stainless steel Weld neck flanges This is planned to be joined to a piping system by buttwelding. It is relatively exclusive because of Its neck but is favored for high-stress applications. The neck or hub conveys stresses to the base of the hub to the wall width at the butt weld, provide important reinforcement of the flange. The bore of the stainless steel Weld neck flange matches the bore of the pipe, reducing turbulence and erosion.

We at Akai Metal India Manufacture stainless steel flanges according to ASME, EN, ISO, and DIN standards. Stainless steel Slip-on flanges have an inner diameter that is a bit bigger than the outer diameter of the pipe flange. Stainless steel Slip-on flanges have a ring located over the end of the pipe and the face of the flanges extends from the pipe end. If Type C stub ends or Type B stub ends are used, these can also be used as lap joint flanges. Flanges slip-on type is an easier way to align, compared to weld neck flanges. On the back of this kind of flanges, is joined the OD of these flanges.

We at Akai Metal India Manufacture stainless steel flanges according to ASME, EN, ISO, and DIN standards. Stainless steel Studding Outlets flanges are mostly provided in SA-105. They can also be made from a full range of stainless steel and alloy materials. The average thickness shown above for all studding outlets is the minutest required per ASME Section VIII Division I Paragraph UG-43(d) for thread engagement and an ID mount. It is significant to note that each separate application should be analyzed for proper thickness.

We at Akai Metal India Manufacture stainless steel flanges according to ASME, EN, ISO and DIN standards. Stainless steel Orifice Flanges are used with orifice beats for the persistence of measuring the flow rate of either liquids or gases in the particular pipeline. Pairs of pressure “Tapping’s”, mostly on 2 sides, directly opposite each other, are machined into the orifice flange. Orifice flanges are basically the same as slip-on flanges or weld neck flanges, the variances being that stainless steel orifice flanges of ASME B16.36 have extra machining and the extra difference is that in the projection ring, orifice flanges have radial, tapped holes.