5 Tips for Passing the Utah Vehicle Safety Inspection

Check your tire treads for signs of wear. If your tires tread depth is less than 2/32 inch in any two tread grooves, it will be rejected. Mismatching tires will also result in a rejection. Tires on the same axle must be the same size or construction although mismatched tread designs are allowed.

Your brake pads need to be checked for wear. Break pads must be no less than 2/32 inch thick to pass the Utah auto safety inspection. In addition to break pads, your parking brake must be functioning and able to hold the vehicle. Be sure that your brakes are in working order.

Your car’s headlamps must be in working order and only project white light. Backup lights must illuminate when the transmission is in reverse. If the backup lights remain illuminated when the transmission is not in reverse, the car will not pass the Utah auto safety inspection.

For cars that have after-market suspension, the chassis and exhaust system of the car cannot be lower than three inches above the ground. During the inspection, the tech will look for and loose parts and also check the struts and shock absorbers for leaks. Make sure these things are taken care of to avoid having to do an additional inspection.

Cracks or damage inside the viewing area of your car’s windshield can result in a rejection for your Utah auto safety inspection. The car’s auto glass will be checked for cracks, scratches, discoloration, and light transmittance. Before having your car inspected, consider auto glass replacement at a windshield repair specialist in Utah.

roa Rock Chip Repair Mobile Replacement Windshield Repair Windshield Replacement Utah Windshield Repair Specialists Here at Diamond Glass, we pledge to provide you with not only the best value, but also the best service. We offer top quality Original Equipment Manufactured (OEM) auto glass and your rock chip repair or windshield replacement will be performed by trained, certified technicians.