Steps to Fix your Car’s Ignition Key

Everyone loves their car and wants their vehicle to be in very good condition. Some of the auto parts are there that need regular check and should be kept up to date all the time. ALTGRAD AUTO is the best place for if you are searching for ford focus 2008 parts.

This is an auto parts shop and they deal with the new as well as old car parts at a very reasonable price and their products will never let you down.

Most the people who own a car face the problem with some specific parts like the battery of the car, the door lock, the damaged headlights, brake rotors of their car and most common problem is the ignition of the car. The ford focus 2008 is the car in which this problem is seen the most.

The first step is to remove the negative terminal of your car’s battery. A proper wrench will be perfect for this step and lose the nut to which the negative cable is connected. Keep the positive terminals of the battery connected to it.

A lot of plastic places surrounds our car. Before you start to change the ignition, remove the plastic trims from the sides of steering and ignition. After that remove the steering wheel from its place.

There are 2 clips on either sides of the ignition; the next step you need to do is to release those clips to loosen the ignition from its place.

The next step is to insert the key and keep your car at ignition position before you remove the ignition module from its place. The accessory position will let you work with vehicles electronic even if the engine is not started. Release the ignition module from its place .

Now since your old ignition is removed now you will buy a new car ignition for your car. Rebuilt of the ignition switch is often difficult. Go for purchasing a new ignition switch along with the new key match to the ignition.

Release the pin on the ignition switch to slide it into the ignition side. These pins will help you to slide in the new ignition switch inside the module easily.

Put the ignition in the hole that is placed for the ignition module with the help of the key and don’t forget to tighten the pin of the ignition.

Now when your new ignition is installed you need to recheck or test it for once. For this you need to reconnect the battery’s negative terminal wire again and then start your car from the ignition.

Give a start to your car from the ignition and be careful and be sure that the ignition is fixed properly otherwise your new ignition switch may damage again.

If you remember, that you’ve removed the steering wheel and the plastic trims from the sides of the ignition before starting all this procedure.

Now if you satisfied with your new ignition and its key then you need you to remove the battery again to avoid any current or damage.

Now if the ignition is working the next step properly you need to follow is to remove the battery again to fix the interior of your steering wheel. Put the plastic trims and the steering wheel back to its place.

The final step is to reconnect the battery again once you’re done with all the steps mentioned above. Your car ignition is fixed.